AccuTemp STEAM'N'HOLD Installatie- en bedieningshandleiding - Pagina 8

Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} AccuTemp STEAM'N'HOLD. AccuTemp STEAM'N'HOLD 15 pagina's. Vacoom steamer

Pagina afdrukken

INSTALLATION-CONT.

ELECTRICAL SUPPLY

The AccuTemp STEAM'N'HOLD™ appliance has

been designed, manufactured and tested to meet

or exceed the Underwriters Laboratories safety

standards. To ensure safety is maintained in your

installation,

it is important that the following paragraphs are

understood before attempting to apply power to

your STEAM'N'HOLD™. If there is any doubt as to

whether your supply receptacle is of the correct

voltage, amperage, or is properly grounded,

consult a qualified electrician or authorized

service agent.

POWER REQUIREMENTS

AC power requirements are listed on the data

plate located on the left side access panel of

the appliance. This appliance should never

be connected to a circuit operating at more

than 150 VAC to ground and should always be

connected to an individual branch circuit. Make

sure the voltage at the supply receptacle is within

±10% of the voltage listed on the appliance data

plate. Connection to any other voltage may

permanently damage your STEAM'N'HOLD™ or

cause premature

component failure. Damage of this type is not

covered under the product warranty. Each

appliance comes equipped with a connected

6 foot power cord and

power requirements of each appliance.

Damage caused by removal or modification of

factory standard plug is not covered by product

warranty.

GROUNDING

To reduce the risk of serious shock or death

in the event of an electrical short circuit,

this appliance must be grounded. The

STEAM'N'HOLD™ is equipped with a cord

having a grounding wire and plug, which must

MP4011-2207

plug, rated for the

STEAM'N'HOLD™

DRAIN

These models do not include a drain

connection and a full size steam table pan or a

1/1 gastronome pan with a minimum depth of

4 inches is required.

The 4"drain pan, part number SH-DP can

be ordered as an accessory . Optionally a

2 1/2"drain pan with an elbow for a drain

connection, part number AT1A-3155 is

available.

HOOD VENTILATION

Some local building codes require the this

appliance to be under an exhaust hood. Please

check local building code requirements before

completing installation of this appliance.