Sharp AQUOS CD-BA250 운영 매뉴얼 - 페이지 10
{카테고리_이름} Sharp AQUOS CD-BA250에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AQUOS CD-BA250 36 페이지. Led backlight tv
Sharp AQUOS CD-BA250에 대해서도 마찬가지입니다: 운영 매뉴얼 (32 페이지), 빠른 매뉴얼 (4 페이지)
![Sharp AQUOS CD-BA250 운영 매뉴얼](/uploads/products/server2/5045561/5045561.jpg)
Turning the TV on/off
Turning on/off the power
• To turn on the power
Press POWER on the TV. (After a few seconds, an image
appears with sound.)
• To turn off the power
Switch it off by pressing POWER on the TV.
Standby mode
• To standby mode
If the TV is switched on, you can switch it to standby
by pressing POWER on the remote control.
• Switching on from standby
From standby, press POWER on the remote control.
NOTE
• If you are not going to use this TV for a long period of time, be
sure to remove the AC cord from the AC outlet.
• Minor power is consumed when the unit is in standby mode.
Initial auto installation
When the TV powers on for the first time after purchase,
the initial auto installation wizard appears. Follow the
menus and make the necessary settings one after
another.
1
Press POWER on the TV.
• The initial auto installation wizard appears.
2
Press a/b to select your country channels listed
on the screen, and then press ENTER.
Press a/b to select "HOME" or "STORE", and
then press ENTER.
• HOME: "STANDARD" will be the default value for the "AV
mode" setting.
• STORE: "DYNAMIC (FIXED)" will be the default value for
the "AV mode" setting. If the "AV mode" is changed, the
TV will automatically switch back to "DYNAMIC (FIXED)"
when there is no further change to TV setting for 30
minutes.
• To change the STORE mode to HOME mode, please
refer to page 14 to reset the unit.
Press a/b to select "D-TV", "A-TV" or
"D-TV + A-TV", and then press ENTER.
• Auto installation will be executed.
• You do not need to do anything during the auto search.
8
Checking Signal information
If you install a DVB-T antenna for the first time or relocate
it, you should adjust the alignment of the antenna to
receive a good reception while checking the antenna
setup screen.
ATV/DTV
ATV/DTV
1
Press MENU and the MENU screen displays.
2
Press c/d to select "
3
Press a/b to select "Digital setting", and then
press ENTER.
4
Press a/b to select "Signal Information", and
then press ENTER.
• The "Signal Information" screen will appear.
" (Programme setup).