Sharp XL-UH2080H 운영 매뉴얼 - 페이지 24
{카테고리_이름} Sharp XL-UH2080H에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp XL-UH2080H 40 페이지.
페이지 인쇄Listening to radio (continued)
XL-UH2080H
Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the
desired frequency band (FM or AM).
3
Press the TUNING (
to tune in to the desired station.
Manual tuning:
Press the TUNING (
to tune in to the desired station.
Auto tuning:
When the TUNING (
0.5 seconds, scanning will start automatically and the tuner
will stop at the first receivable broadcast station.
Notes:
When radio interference occurs, auto scan tuning may stop
automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING (
When an RDS (Radio Data System) station is tuned in, the
frequency will be displayed first, and then the RDS indicator will
light up. Finally, the station name will appear.
Full auto tuning can be achieved for RDS stations "ASPM", see
page 26.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to select stereo mode and "ST"
indicator will be displayed.
" " will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER (BAND) button to
extinguish the "ST" indicator. The reception changes to
monaural, and the sound becomes clearer.
24
or
) button on the remote control
or
) button as many times as required
or
) button is pressed for more than
or
) button again.
FM stereo mode indicator
FM stereo receiving indicator
Memorising a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
1
Perform steps 1 - 3 in "Tuning" on page 24.
2
Press the MEMORY button to enter the preset tuning
saving mode.
3
Within 30 seconds, press the PRESET (
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 30 seconds, press the MEMORY button to store that
station in memory.
If the "MEMORY" and preset number indicators disappear
before the station is memorised, repeat the operation from step
2.
5
Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station previously
memorised for that preset channel number will be erased.
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead become
disconnected.
or
) button to