Sharp AL-1035-WH A 운영 매뉴얼 - 페이지 20
{카테고리_이름} Sharp AL-1035-WH A에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AL-1035-WH A 50 페이지. Digital multifunctional system
Sharp AL-1035-WH A에 대해서도 마찬가지입니다: 수동 시작 (28 페이지)
페이지 인쇄
ID CARD COPY
To print both sides of an ID card onto paper according to the specified pattern. The specified patterns for ID card
copying are shown as follows.
• To copy an ID card, operate according to the following steps.
Note
• ID Card Copy cannot be used together with 2 in 1 or manual ratio selection.
• Usable paper: A4 or letter.
• The image may be cut off even if paper of standard size is used.
• In ID Copy mode, the scan area and number of copies (1 copy) cannot be changed. By selecting ID Copy mode,
the number of copies is automatically set to be 1 Copy.
• Maximum ID Card size:X 148mm,Y 210mm.
• Image loss:1.5mm.
• Pressing the [SCAN to USB] key (
document to USB device.
1
Open the cover, and place the ID card
on the document glass, aligning it in
portrait on the corner at the right side
of the document glass (
2
Press the [MODE SELECT] key and
select [ID MODE] to light up its
indicator.
ID Card A1
ID Card B1
) instead of [COPY START] key (
) .
The ID Copy indicator will
light up. The original
exposure level can be
changed as needed.
ID Card A2
ID Card B2
3
Press the [COPY START] key (
After scanning one side, press the [CLEAR]
Note
key (
you press the [CLEAR] key (
ID Copy mode will be cancelled, and it will
return to the 100% copy mode.
4
Open the cover and turn the ID card
over on the document glass.
When the LED indicator and ID Copy indicator
both blink, turn over the ID card in time. If it is not
turned over within 30 seconds, the copying will be
cancelled.
5
Press the [COPY START] key (
again.
When the scan is finished, Copy will begin.
19
COPY FUNCTIONS
) enables ID card scan on one
), the relevant data will be cleared. If
) again, the
).
)