Sharp AR-C360P 소프트웨어 설치 매뉴얼 - 페이지 27

{카테고리_이름} Sharp AR-C360P에 대한 소프트웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-C360P 29 페이지. Sharp ar-c360p: supplementary guide
Sharp AR-C360P에 대해서도 마찬가지입니다: 인쇄 매뉴얼 (46 페이지)

페이지 인쇄
Sharp AR-C360P 소프트웨어 설치 매뉴얼
12. Secure the stacker with four screws.
13. Push the finisher against the printer until the
prongs on the printer brackets fit into the
holes in the finisher.
If you need to, turn the levellers (
Note:
either side of the finisher to raise or
lower it so the holes and prongs align
properly. Make sure the finisher is level.
Step 5: Make Connections
1. Connect the finisher's cable to the inverter
(
!
). Use the cable supplied to connect the
inverter to the printer (
2. Plug the power cord supplied into the
!
) on
inverter, then connect it to a suitable
grounded outlet.
3. Reconnect the printer's interface cable.
4. Plug in the printer's power cord and turn on
the printer.
Note:
"
).
When the printer is turned on, power
is supplied to both the printer and the
finisher.