Sharp AR-M160 소프트웨어 설정 매뉴얼 - 페이지 10

{카테고리_이름} Sharp AR-M160에 대한 소프트웨어 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp AR-M160 20 페이지. Digital document solutions
Sharp AR-M160에 대해서도 마찬가지입니다: 온라인 매뉴얼 (33 페이지), 브로셔 및 사양 (6 페이지)

페이지 인쇄
Sharp AR-M160 소프트웨어 설정 매뉴얼
INSTALLING THE SOFTWARE
INSTALLATION IN WINDOWS 95/98/ME/NT4.0/2000
(PARALLEL CABLE)
1
The USB or parallel cable must not be
connected to the machine. Make sure
that the cable is not connected before
proceeding.
If the cable is connected, a Plug and Play window
will appear. If this happens, click the "Cancel" button
to close the window and disconnect the cable.
Note
The cable will be connected in step 17.
2
Insert the CD-ROM into your CD-ROM
drive.
3
Double-click "My Computer" (
then double-click the CD-ROM icon (
4
Double-click the "setup" icon (
If the language selection screen appears after
Note
you double click the "setup" icon, select the
language you wish to use and click the "Next"
button. (Normally the correct language is
selected automatically.)
5
Select the software packages to be
installed and then click the "Next"
button.
Software packages with a checkmark ( ) in the
list on the screen will be installed.
Click the "Display README" button to show
information on packages that are selected.
• In Windows 95/NT 4.0, "Button Manager"
Note
does not appear.
• In Windows 98/Me/2000, do not select the
"Button Manager" checkbox (Button
Manager is not supported when a parallel
cable is used).
8
6
Check the packages on the screen,
and then click the "Start" button.
The software packages to be installed will be
displayed on the screen. If an incorrect package
is displayed, click the "Back" button and select
the correct packages.
7
Begin installation of the MFP driver
(printer driver) (if "MFP driver" was
selected in Step 5).
Follow the on-screen instructions.
If you are using Windows 95/NT 4.0, go to step 10.
8
When you are asked how the printer is
connected, select "Connected to this
), and
computer" and click the "Next" button.
).
).
9
When the interface selection screen
appears, select "Parallel" and click
the "Next" button.