Crestron CLS-SLVS1 사용자 설명서 - 페이지 2

{카테고리_이름} Crestron CLS-SLVS1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron CLS-SLVS1 11 페이지. Stand-alone wall box switch

페이지 인쇄
CLW-SW1, SWS1, & SLVS1(W/A/B)

Physical Description

The -SW1 and -SWS1 contain one large pushbutton, a
light emitting diode (LED) with software adjustable
brightness*, and a three-position slider-switch, shown
after this paragraph. Line voltage connections are made at
the rear of the switch. Three Class 2 low voltage wires,
located on the front of the switch, provide a Cresnet
connection to a control system. The wires can be routed to
the bottom of the unit for placement outside of the wall
box. The -SLVS1 is similar to the -SW1 and -SWS1 but
does not have the slider-switch or the Class 2 low voltage
wires.
*
LED brightness can only be adjusted through Crestron programming
software.
CLW-SW1/SWS1 (L) and CLW-SLVS1 (R) shown in white
Physical view of CLW-SW1/SWS1 (clockwise from top; Top,
Side, and Front)
1.75 in
(4.45 cm)
2.38 in
(6.03 cm)
3.81 in
(9.68 cm)
3.28 in
(8.32 cm)
2 • Stand Alone Wall Box Switch: CLW-SW1, SWS1, & SLVS1
1.91 in
(4.85 cm)
2.70 in
4.13 in
(6.86 cm)
(10.48 cm)
1.50 in
(3.81 cm)
Physical view of CLW-SLVS1 (clockwise from top; Top, Side,
and Front)
1.75 in
(4.45 cm)
3.81 in
(9.68 cm)
3.28 in
(8.32 cm)
(10.48 cm)
The -SW1, -SWS1, and -SLVS1 mount in a standard
wallbox and are covered using a decorative faceplate (not
included).

Industry Compliance

This product is Listed to applicable UL Standards and
requirements by Underwriters Laboratories Inc.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
CAUTION: Changes or modifications not expressly
approved by the manufacturer responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning
Installation Guide – DOC. 6251A
1.91 in
(4.85 cm)
2.70 in
4.13 in
(6.86 cm)
1.50 in
(3.81 cm)
E239013