Digital Acoustics IP7-SS40 참조 매뉴얼 - 페이지 13

{카테고리_이름} Digital Acoustics IP7-SS40에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Acoustics IP7-SS40 20 페이지. Audio transformer
Digital Acoustics IP7-SS40에 대해서도 마찬가지입니다: 설치 지침 (2 페이지)

페이지 인쇄

Connecting Line Out

The Line Out connector is designed to drive a 600 Ohm unbalanced

load at -10db. This is capable of driving a powered multimedia

speaker

 Connect J2-3 to the + side of the output source

 Connect J2-4 to the - side of the output source

 Cable length should not exceed 6ft (2 meters)

 Use 22 AWG shielded/stranded cable

Connecting an I2C Bus

The IP7-SS40 can support an optional I2C bus via the RJ-10 connecter.

Buttons, relays and LEDs can be added to the I2C bus, BUT REQUIRE

CUSTOM FIRMWARE AND SOFTWARE. Please contact Digital Acoustics

for additional information.

Mounting Instructions

The IP7-SS40 can be installed on a DIN Rail or surface mounted.

Din Rail Mounting

To DIN rail mount:

 Cut a piece of 35mm DIN rail (not supplied) to the desired length

and secure it to the wall

 Place the IP7-SS40 onto the DIN rail by tilting the top of the unit

(J1, J2, J3 connectors facing up with Volume buttons and USB-B

connector facing forward) back towards the DIN Rail until the

IP7-SS40s DIN clip catches the top of the rail

 Press in at the bottom of the IP7-SS40 to snap it in place

Surface Mounting

To surface mount:

 Attach the detachable surface mount plate

to the back of the unit using the provided

screws. The two mounting holes of the

surface mount plate should be above the J1,

J2, and J3 connectors

 Attach two (2) #8 pan head screws 2 inches

(52 mm) apart and screw in to within ¼"

 Place the mounting holes of the IP7-SS40 over the #8 screws