Sharp Notevision XG-C330X 설정 매뉴얼 - 페이지 41

{카테고리_이름} Sharp Notevision XG-C330X에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Notevision XG-C330X 45 페이지. True xga portable lcd projectors
Sharp Notevision XG-C330X에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 사양 (2 페이지), 사양 (2 페이지)

페이지 인쇄
Sharp Notevision XG-C330X 설정 매뉴얼

Troubleshooting

Communication cannot be established with the projector
When connecting the projector using serial-connection
\ Check that the RS-232C terminal of the projector and a computer or the commercially
available controller are connected correctly.
\ Check that the RS-232C cable is a cross-over cable.
\ Check that the RS-232C port setting for the projector corresponds to the setting for the
computer or the commercially available controller.
When connecting the projector to a computer using network (LAN)-
connection
\ Check that the cable's connector is firmly inserted in the LAN terminal of the projector.
\ Check that the cable is firmly inserted into a LAN port for a computer or a network device
such as a hub.
\ Check that the LAN cable is a Category 5 cable.
\ Check that the LAN cable is a cross-over cable when connecting the projector to a computer
directly.
\
Check that the LAN cable is a straight-through cable when connecting the projector with a
network device such as a hub.
\
Check that the power supply is turned on for the network device such as a hub between the
projector and a computer.
Check the network settings for the computer and the projector
\ Check the following network settings for the projector.
• IP Address
• Subnet Mask
• Gateway
• The factory default settings for the projector are as follows:
• For network settings for the projector, refer to page 22.
Check that the IP address for the projector is not duplicated on the network.
When the gateway setting for the projector is "0.0.0.0" (Not Used), or the gateway setting for
the projector and the default gateway setting for the computer are the same:
• The subnet masks for the projector and the computer should be the same.
• The IP address parts shown by the subnet mask for the projector and the computer should
be the same.
(Example)
When the IP address is "192.168.150.2" and the subnet mask is "255.255.255.0" for the
projector, the IP address for the computer should be "192.168.150.X" (X=3-254) and the
subnet mask should be "255.255.255.0".
When the gateway setting for the projector is "0.0.0.0" (Not Used), or the gateway setting for
the projector and the default gateway setting for the computer are the same:
• The subnets for the projector and the computer should be the same.
• The IP address parts shown by the subnet mask for the projector and the computer should
be the same.
(Example)
When the IP address is "192.168.150.2" and the subnet mask is "255.255.255.0" for the
projector, the IP address for the computer should be "192.168.150.X" (X=3-254) and the
subnet mask should be "255.255.255.0".
Note
DHCP Client : Off
IP address : 192.168.150.2
Subnet mask : 255.255.255.0
Gateway address : 0.0.0.0 (Not Used)
-41