Sharp Notevision XG-C330X 설정 매뉴얼 - 페이지 43

{카테고리_이름} Sharp Notevision XG-C330X에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp Notevision XG-C330X 45 페이지. True xga portable lcd projectors
Sharp Notevision XG-C330X에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 사양 (2 페이지), 사양 (2 페이지)

페이지 인쇄
Sharp Notevision XG-C330X 설정 매뉴얼
\ Check if the "TCP/IP" protocol is operating correctly using the "PING" command. Also, check
if an IP address is set.
1. Open a command prompt (MS-DOS Prompt).
2. After launching the command prompt (MS-DOS Prompt) enter a command "PING".
3. When connecting normally, the display will be as follows.
4. When a command cannot be sent, "Request time out" will be displayed.
5. To return to the Windows
A connection cannot be made because you have forgotten your user name or your password.
\ Initialize the settings. (See page 54 of the projector's operation manual.)
\ After the initialization, carry out setting again.
• In the case of Windows
order.
• In the case of Windows
Prompt" in order.
• In the case of Windows
Prompt" in order.
®
• In the case of Windows
Prompt" in order.
Entry example C:\>Ping XXX.XXX.XXX.XXX
"XXX.XXX.XXX.XXX" should be entered with an IP address to be connected to, such as
the projector.
(The screen may be slightly different depending on the OS type).
<Example> when the IP address connected to is "192.168.150.2"
Check the network setting again.
If communication can still not be established properly, contact your network administrator.
98 or 98SE: click "START" ➔ "Programs" ➔ "MS-DOS Prompt" in
®
Me: click "START" ➔ "Programs" ➔ "Accessories" ➔ "MS-DOS
®
2000: click "START" ➔ "Programs" ➔ "Accessories" ➔ "Command
®
XP: click "START" ➔ "All Programs" ➔ "Accessories" ➔ "Command
®
screen, enter "exit" and then press the "Enter" key.
Troubleshooting
-43