Crestron 4 Series 빠른 시작 - 페이지 2

{카테고리_이름} Crestron 4 Series에 대한 빠른 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. Crestron 4 Series 5 페이지. Control processor for zūm lighting control system
Crestron 4 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 시작하기 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (12 페이지)

페이지 인쇄
Crestron 4 Series 빠른 시작
CP4/CP4N
4-Series Control System

Connect the Device

Make all necessary connections to the control system as shown below.
Observe the following when connecting the control system:
Use Crestron power supplies for Crestron equipment.
l
The control system may be powered with the included 24 VDC power
l
supply or via Cresnet® network power with the NET port.
Connect the chassis ground lug to a known earth ground circuit (such
l
as building steel) to ensure that the control system is grounded
properly.
Apply power after all connections have been made.
l
COM 1 Connections
Port
RS-232
G
GND
TX
TX (from CP4/CP4N)
RX
RX (to CP4/CP4N)
RTS
RTS (from CP4/CP4N)
CTS
CTS (to CP4/CP4N)
1. RS-422 transmit and receive are balanced signals that require two lines plus a ground
in each direction. RXD+ and TXD+ should idle high (going low at start of data
transmission). RXD- and TXD- should idle low (going high at start of data
transmission). If necessary, RXD+/RXD- and TXD+/TXD- may be swapped to maintain
correct signal levels.
2. A ground terminal connection is recommended but not required.
Quick Start
1
RS-422
RS-485
2
GND
GND
TX- (from CP4/CP4N)
TX-/RX-
RX+ (to CP4/CP4N)
Not used
TX+ (from CP4/CP4N)
TX+/RX+
RX- (to CP4/CP4N)
Not used
2