Shimano Alfine S7000 Series 딜러 매뉴얼 - 페이지 19
{카테고리_이름} Shimano Alfine S7000 Series에 대한 딜러 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano Alfine S7000 Series 47 페이지.
페이지 인쇄
- 1. Installation of the Cs-S500 Sprocket with Chain Guard
- 2. Installation of the Shifting Lever
- 3. Installation of the Shifting Cable
- 4. Adjusting the Cassette Joint
- 5. Replacement and Assembly of the Indicator Unit
- 6. For Internal 8-Speed (Oil Maintenance Kit: Y00298010)
- 7. In the Case of 11-Speed Internal Geared Hub (Oil Maintenance Kit: Y13098023)
INSTALLATION
Installation of the shifting cable
2
3
(A)
4
(A)
5
(B)
To be continued on next page
Loosen and remove the wire end
hooking cap.
(A)
Insert the inner cable into the groove in
the winder unit, and then pass it
through the hole in the cable adjustment
barrel.
(B)
Pull the inner cable so that the inner
cable drum fits into the hole in the
winder unit.
(B)
Screw in the wire end hooking cap as
shown in the illustration until it stops.
(A)
If it is turned any further, it will damage
the screw thread in the cover.
In addition, the unit cover may become
bent, which may cause an obstruction
between the unit cover and the main
lever, and the main lever may not
operate correctly.
If the main lever does not return
(C)
properly, loosen the wire end hooking
cap slightly to make a gap between the
main lever and the unit cover, and check
that this improves the returning of the
main lever.
19
(A)
Wire end hooking cap
(A)
Hole in cable adjustment barrel
(B)
Groove in winder unit
(A)
Inner cable drum
(B)
Hole in winder unit
(A)
Wire end hooking cap
(B)
Unit cover
(C)
Main lever