Shimano Alfine S7000 Series Dealer's Manual - Page 19
Browse online or download pdf Dealer's Manual for Bicycle Accessories Shimano Alfine S7000 Series. Shimano Alfine S7000 Series 47 pages.
Print Page
- 1. Installation of the Cs-S500 Sprocket with Chain Guard
- 2. Installation of the Shifting Lever
- 3. Installation of the Shifting Cable
- 4. Adjusting the Cassette Joint
- 5. Replacement and Assembly of the Indicator Unit
- 6. For Internal 8-Speed (Oil Maintenance Kit: Y00298010)
- 7. In the Case of 11-Speed Internal Geared Hub (Oil Maintenance Kit: Y13098023)
INSTALLATION
Installation of the shifting cable
2
3
(A)
4
(A)
5
(B)
To be continued on next page
Loosen and remove the wire end
hooking cap.
(A)
Insert the inner cable into the groove in
the winder unit, and then pass it
through the hole in the cable adjustment
barrel.
(B)
Pull the inner cable so that the inner
cable drum fits into the hole in the
winder unit.
(B)
Screw in the wire end hooking cap as
shown in the illustration until it stops.
(A)
If it is turned any further, it will damage
the screw thread in the cover.
In addition, the unit cover may become
bent, which may cause an obstruction
between the unit cover and the main
lever, and the main lever may not
operate correctly.
If the main lever does not return
(C)
properly, loosen the wire end hooking
cap slightly to make a gap between the
main lever and the unit cover, and check
that this improves the returning of the
main lever.
19
(A)
Wire end hooking cap
(A)
Hole in cable adjustment barrel
(B)
Groove in winder unit
(A)
Inner cable drum
(B)
Hole in winder unit
(A)
Wire end hooking cap
(B)
Unit cover
(C)
Main lever