Shimano Alfine S7000 Series 딜러 매뉴얼 - 페이지 6
{카테고리_이름} Shimano Alfine S7000 Series에 대한 딜러 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano Alfine S7000 Series 47 페이지.
- 1. Installation of the Cs-S500 Sprocket with Chain Guard
- 2. Installation of the Shifting Lever
- 3. Installation of the Shifting Cable
- 4. Adjusting the Cassette Joint
- 5. Replacement and Assembly of the Indicator Unit
- 6. For Internal 8-Speed (Oil Maintenance Kit: Y00298010)
- 7. In the Case of 11-Speed Internal Geared Hub (Oil Maintenance Kit: Y13098023)
TO ENSURE SAFETY
Be sure to also inform users of the following:
• Shift the shifting lever one or two gears at a time. During shifting, reduce the force being applied to the pedals. If you try to force operation of the
shifting lever or shift three or more gears while the pedals are being turned strongly, your feet may come off the pedals and the bicycle may fall over,
which could result in serious injury.
Operating the shifting lever to multi-shift to a light gear may also cause the outer casing to spring out of the shifting lever. This does not affect the
capabilities of the shifting lever because the outer casing returns to the original position after shifting.
Disc brake
• Disc brakes have a burn-in period, and braking force will gradually increase as the burn-in period progresses; therefore, make sure that you are aware
of any such increases in braking force when using the brakes during this period. The same thing will happen when the brake pads or disc brake rotor
are replaced.
Be sure to also inform users of the following:
• You can shift gears while lightly pedaling, but on rare occasions the pawls and ratchet inside the hub may produce some noise afterwards as part of
normal gear shifting operation.
• The internal hub is not completely waterproof. Avoid using the hub in places where water might get inside it and do not use high-pressure water to
clean the hub, otherwise the internal mechanism may rust.
• Do not disassemble the hub. If you need to disassemble it, consult the dealer where you made a purchase.
• The internal geared hub has a built-in mechanism to support shifting, and when this support mechanism operates during shifting, noise or vibration
may occur. Depending on gear position, gear-shifting may feel different.
Noise may also occur if the gear is positioned at 5 to 8 (internal 8-speed hub) or 7 to 11 (internal 11-speed hub), when the crank is turned backward or
when the bicycle is pushed backward.
All of these phenomena occur due to the built-in gear-shifting structure and are not the failure of the internal components.
• Products are not guaranteed against natural wear and deterioration from normal use and aging.
• For maximum performance we highly recommend Shimano lubricants and maintenance products.
CAUTION
NOTE
6