Shimano BL-C6000 딜러 매뉴얼 - 페이지 12

{카테고리_이름} Shimano BL-C6000에 대한 딜러 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano BL-C6000 27 페이지. Hub roller brake

페이지 인쇄

INSTALLATION

Installation of the hub to the frame

Rear side

The hub installation is an example. Also refer to the manual for the hub.

(C)

(E)

Dropouts

Standard

Reversed

(full chain

case)

Vertical

Note: vertical: excluding the coaster specifications

To be continued on next page

(A)

(B)

(D)

(F)

(G)

Non-turn washer

Mark/Color

Right

Left

5R/Yellow

5L/Brown

7R/Black

7L/Gray

6R/Silver

6L/White

5R/Yellow

5L/Brown

8R/Blue

8L/Green

Mount the chain on the sprocket, and

then set the hub axle (A) into the

dropouts (B).

Place the non-turn washers onto the

right side and left side of the hub axle.

At this time, turn the cassette joint (E)

so that the projecting parts of the non-

turn washers fit into the grooves of

the dropouts (D). If this is done, the

cassette joint can be installed so that it

is almost parallel to the chainstay (F).

Size

ϴ ≤ 20°

20° ≤ ϴ ≤ 38°

ϴ = 0°

ϴ = 60° - 90°

(A)

Hub axle

(B)

Dropouts

(C)

Non-turn washer (for left side)

(D)

Grooves of the dropouts

(E)

Cassette joint

(F)

Chainstay

(G)

Non-turn washer (for right side)

NOTE

When installing a part such as a mudguard

stay to the hub axle, install in the order

shown in the illustration below.

Non-turn

washer

Mudguard stay

Carrier stay

•

Use whichever non-turn washers match

the shape of the dropouts. Different non-

turn washers are used at the left and

right sides.

•

The projecting parts should be on the

dropouts side.

•

Install the non-turn washers so that the

projecting parts is securely in the

dropouts grooves on either side of the

hub axle.

Mark

Washer

Cap nut