Shimano BL-C6000 딜러 매뉴얼 - 페이지 23
{카테고리_이름} Shimano BL-C6000에 대한 딜러 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano BL-C6000 27 페이지. Hub roller brake
페이지 인쇄
- 1. Table of Contents
- 1. Important Notice
- 2. To Ensure Safety
- 3. Installation
- 3. List of Tools to be Used
- 3. Installation of the Lever
- 3. Installing the INTER M Brake to the Hub Body
- 3. Installation of the Hub to the Frame
- 3. Installation of the Brake Cable
- 4. Adjustment
- 4. Adjusting the Brake Cable
- 5. Maintenance
- 5. Applying Grease
ADJUSTMENT
Adjusting the brake cable
ADJUSTMENT
Adjusting the brake cable
Rear side
1
(a)
2
(A)
3
After checking that the wheel does not
easily turn while the brake cable is
being pulled, depress the brake lever
about 10 times as far as the grip in
order to run in the brake cable.
(A)
Turn the cable adjustment barrel (A) of
the brake unit or brake lever so that
there is a 15 mm gap (a) (11 mm for
BL-C6010) in the brake lever.
(The amount of brake lever gap is the
distance from the position where the
brake lever is not operated to the
position where a force is felt suddenly
when the brake lever is pulled.)
After depressing the brake lever to
check the braking performance, secure
the cable adjustment barrel with the
cable adjustment nut (B).
(B)
23
NOTE
If the brake cable is not run in, it will need
to be adjusted again after only a short
period of use.
(A)
Cable adjustment barrel
(B)
Cable adjustment nut
Tightening torque
1 - 2 N·m