Shimano BR-M6000 딜러 매뉴얼 - 페이지 22

{카테고리_이름} Shimano BR-M6000에 대한 딜러 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano BR-M6000 39 페이지. Hydraulic disc brake
Shimano BR-M6000에 대해서도 마찬가지입니다: 딜러 매뉴얼 (39 페이지)

페이지 인쇄

MAINTENANCE

Adding Shimano genuine mineral oil and bleeding air

Set the lever unit to the horizontal

position as shown in the illustration and

[1]

tilt it in the direction of [1] by 30°, and

(z)

then carry out step 9 to check that there

is no air remaining.

(z)

Next, tilt the lever unit 30° in the

[2]

direction of [2], and carry out step 9

again to check that there is no air

remaining.

If any air bubbles appear, repeat the

above procedure until they stop

appearing.

(z)

Plug the oil funnel with the oil stopper

so that the side with the O-ring attached

(A)

is facing downward.

(B)

Remove the oil funnel while it is still

being plugged with the oil stopper, and

then attach the O-ring to the bleed

screw and tighten it until oil flows out to

make sure that there are no air bubbles

remaining inside the reservoir tank.

(A)

Wipe away any oil that has overflowed.

30°

(A)

Oil stopper

(B)

O-ring

(A)

O-ring

Tightening torque

0.5 - 1 N·m

NOTE

Do not operate the brake lever. If operated,

there is a risk of air bubbles entering the

cylinder.