Shimano BR-M6000 Manual do Concessionário - Página 22
Procurar online ou descarregar pdf Manual do Concessionário para Acessórios para bicicletas Shimano BR-M6000. Shimano BR-M6000 39 páginas. Hydraulic disc brake
Também para Shimano BR-M6000: Manual do Concessionário (39 páginas)
Imprimir página
- 1. Table of Contents
- 1. Important Notice
- 2. To Ensure Safety
- 3. List of Tools to be Used
- 4. Installation
- 4. Disc Brake Mount Adapter (for 180Mm Disc Brake Rotors)
- 4. Disc Brake Rotor Adapter
- 4. Brake Hose
- 5. Maintenance
- 5. Adding Shimano Genuine Mineral Oil and Bleeding Air
- 5. Replacing the Brake Hose
- 5. Replacing the Brake Pads
MAINTENANCE
Adding Shimano genuine mineral oil and bleeding air
10
11
12
13
Set the lever unit to the horizontal
position as shown in the illustration and
[1]
tilt it in the direction of [1] by 30°, and
(z)
then carry out step 9 to check that there
is no air remaining.
(z)
Next, tilt the lever unit 30° in the
[2]
direction of [2], and carry out step 9
again to check that there is no air
remaining.
If any air bubbles appear, repeat the
above procedure until they stop
appearing.
(z)
Plug the oil funnel with the oil stopper
so that the side with the O-ring attached
(A)
is facing downward.
(B)
Remove the oil funnel while it is still
being plugged with the oil stopper, and
then attach the O-ring to the bleed
screw and tighten it until oil flows out to
make sure that there are no air bubbles
remaining inside the reservoir tank.
(A)
Wipe away any oil that has overflowed.
30°
22
(A)
Oil stopper
(B)
O-ring
(A)
O-ring
Tightening torque
0.5 - 1 N·m
NOTE
Do not operate the brake lever. If operated,
there is a risk of air bubbles entering the
cylinder.