Shimano ST-5500-CA 서비스 지침 매뉴얼 - 페이지 6
{카테고리_이름} Shimano ST-5500-CA에 대한 서비스 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano ST-5500-CA 10 페이지. Ultegra series shifter
페이지 인쇄
• Rear lever
Push lever
at least 8 times
B
F
to make sure the mechanism
is in top gear
Lever
before installing.
Depress the brake lever, and then
pass the inner cable through the
cable hole.
If the cable hook does not align with the shifting cable
hole, press lever
B
again until it does, and then install
F
the cable.
Cable hook
Make sure that the inner end is firmly seated in the
cable hook.
Inner end
Cable hook
F
B
Operate at
least 8 times
Cable hole
Inner cable
• Front lever
Push lever
at least
b
F
two - three times
before installing.
Operate at least 2 - 3 times
Pull the brake lever
(as when braking) to pass
Shifting cable hole
the inner cable through the
shifting cable hole, and set
it in the outer casing.
Outer casing
• Outer stopper
1. Install the outer stopper to the down tube.
Direct mount seat (M5)
Tightening torque:
1.5 - 2 N·m {13 - 18 in. lbs.}
Install the outer stopper for
the rear chainwheels with
Handle default
position
the handle in the default
position.
2.
Pass the inner cable through, and set the outer casing.
Be sure leave some excess in the outer casing, even if
cutting it to the full length of the handlebars.
Outer stopper
Inner cable
Confirm
Make sure the outer
casing is firmly seated
in the outer stopper.
Lever
b
F
Inner cable
Outer stopper
Installation bolt
3mm Allen key
Outer casing