Shimano ST-5500-CA 서비스 지침 매뉴얼 - 페이지 7
{카테고리_이름} Shimano ST-5500-CA에 대한 서비스 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano ST-5500-CA 10 페이지. Ultegra series shifter
페이지 인쇄
Maintenance
Bracket and lever disassembly
1.
Remove the sensor cap,
and the use a 2 mm Allen
key to remove the lever
stud set screw on the
bottom of the bracket.
Lever stud set screw
2.
Insert a 2.5 mm Allen key or similar tool into the lever
stud hole, and tap it gently with a plastic mallet to push
out the lever stud. When the lever stud comes out, the
bracket body and lever body can be disassembled.
After this, pull the sensor cable out from the bracket
body.
Note:
When removing
the sensor cable,
do not apply too
much force when
pulling the cable,
otherwise the
sensor may
become damaged.
Use a tool to hold
the sensor in place
and pull the cable
out carefully.
Lever and bearing assembly
disassembly
1.
Remove the cable hook.
2.
Disassemble using the special tool and
a 5 mm Allen key.
Torque tightening during assembly:
8 - 10 N·m {70 - 85 in. lbs.}
Special tool (TL-ST01)
5 mm Allen key
Sensor cap
2 mm Allen key
Sensor
➀
Sensor cable
➁
Bracket
body
Lever body
Cable hook