Shimano Ultegra 6770 Series 매뉴얼 - 페이지 14

{카테고리_이름} Shimano Ultegra 6770 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Shimano Ultegra 6770 Series 24 페이지.

$ Installation and removal of the battery

Open the clamp, and then install the battery so that it follows the groove in the battery mount. Close the clamp until it clicks

into place.

Open the clamp, pull out the battery slightly, and then press the button to fully remove the battery.

$ Rear junction: Connection of junction (B)

External type (SM-JC40)

Connect the electric wires to junction (A) and junction (B). Be sure to push them together until they

connect with a click.

Junction (B)

Clearance

Junction (A)

Connect the electric wires to the front derailleur, the rear derailleur and the battery mount.

At front derailleur

At rear derailleur

Provisionally secure the electric wire along the frame with tape, and

then connect it to junction (B).

* When routing the electric wire to the rear derailleur, be sure to

install it to the bottom of the chainstay to avoid any interference

between the cable and the chain.

* Wind any excess length of electric wire inside junction (B) to adjust

the length.

Example of adjusting junction (B) length

At battery mount