Digital China Networks WL8200-I2 설치 매뉴얼 - 페이지 8

{카테고리_이름} Digital China Networks WL8200-I2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital China Networks WL8200-I2 13 페이지. Wl8200 series

Wireless Access Point

Installation Manual

3.2 Checking before Installation

Please check the following items before the AP installation:



Please power to the AP first and connect the AP to the Ethernet, then check the

LED status to make sure the AP can work normally.



Please ensure to complete the wiring in the position of AP installation.



WL8200 series indoor AP supports 802.3af and 802.3at standard PoE (Power

over Ethernet) power. If user wants to get the maximum performance, user can

use the 1000M connection method.



Please record AP's MAC address and serial number (MAC address and serial

number are on the back of the AP) first for convenient to find and use.

The rules of installation position are as below:



Cut back the obstacles (such as walls) between AP and the user terminal device

as much as possible.



Make the AP's position far away from the electrical device that can bring the RF

noise (such as the microwave).



The installation position should be hidden as much as possible to prevent

disturbing the inhabitants.



Strictly forbid to install the AP in the environment with hydrocephalus, seepage,

water-clock and co ndensation. And user should avoid the water flowing into the

device along the cable.

If there is outdoor cable, please check if installed the network port SPD beside the AP,

the network port SPD should be provided by user.

WL8200 Series can be installed indoor only and there are two methods supported:





T-keel installation

3.4.1 Wall Hanging Installation

If install the AP on the wall, use the supporting expansion screw tubes and screws of

the wall mounting. After received the device, the expansion screw tubes and screws as

below in the accessory bag can be found.

Chapter 3 AP Installation

3-2