Digital China Networks WL8200-I2 설치 매뉴얼 - 페이지 9

{카테고리_이름} Digital China Networks WL8200-I2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital China Networks WL8200-I2 13 페이지. Wl8200 series

Wireless Access Point

Installation Manual

When installed with wall hanging method, please connect the Ethernet cable to the

AP first and then install the AP on the wall mounting bracket.

(1) Connect the AP to the wired LAN by using the cable

(2) Mark the positions of two holes on the wall and the distance between them is 65

mm. And then punch two holes with the impact drill;

(3) Insert the expansion bolt into the holes and use the rubber hammer beating it until

the expansion bolt got into the wall completely;

(4) Screw the screws in the two plastic expansion screw tubes. Please do not screw

them in the tubes completely, keep 3-5 mm out of them;

(5) Make the two holes on the back of the AP hang on the two screws;

(6) After hanging the AP, push the AP down and the AP will be locked on the wall. The

installation steps are as below:

Punch and nail on the wall

3.4.2 T-keel Installation

Fig 3-2 wall mounting screws

Stuck the AP on the screws

Fig 3-3 steps of wall hanging installation

3-3

Chapter 3 AP Installation

Complete the installation