Digital Control Systems AirSense 310en 운영자 매뉴얼 - 페이지 7
{카테고리_이름} Digital Control Systems AirSense 310en에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Control Systems AirSense 310en 19 페이지. Infrared environmental co2 sensor
페이지 인쇄Installation
3.20"
2.10"
1.60"
1.10"
0.00"
Figure 1: AirSense Model 310en Mounting Dimensions
Cover Removal
To open the Model 310en use a coin in the slot on the
bottom to release the snap. Lift the cover up slightly to
disengage the closure and remove cover with a downward
motion to clear the catch at the top of the unit.
The locations of controls and terminals on the main circuit
board are shown in the Figure 2 on page 5.
Mounting
The Model 310en is designed for flush mounting with two
fasteners. The locations of the mounting points (shown in
Figure 1) allow direct mounting on a standard simplex
(single circuit) junction box. There is a wiring cutout in the
center of the unit near the terminal strips.
3/9/15
AirSense Model 310en Operator's Manual
Digital Control Systems
www.dcs-inc.net • 503/246-8110
4
Page: