Digital Electronics FP790-T21 설치 매뉴얼 - 페이지 6

{카테고리_이름} Digital Electronics FP790-T21에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Electronics FP790-T21 17 페이지. Flat panel display

페이지 인쇄

General Specifications

Electrical

Input Voltage

Rated Voltage

Frequency

Allowable Voltage Drop

Power Consumption

In-Rush Current

Voltage Endurance

Insulation Resistance

Environmental

Ambient Operating

Temperature

(Cabinet interior and exterior)

Storage Temperature

Ambient Humidity

Air Purity Level

Atmosphere

Vibration Resistance

Noise Endurance

(via noise simulator)

Structural

Grounding

Rating

Cooling Method

Weight

External Dimensions

*1 The front face of the PL unit, installed in a solid panel, has been tested using conditions equivalent to

the standard shown in the specification . Even though the PL unit's level of resistance is equivalent to

the standard, oils that should have no effect on the PL can possibly harm the unit. This can occur in

areas where either vaporized oils are present, or where low viscosity cutting oils are allowed to

adhere to the unit for long periods of time. If the PL's front face protection sheet becomes peeled off,

these conditions can lead to the ingress of oil into the PL and separate protection measures are

suggested. Also, if non-approved oils are present, it may cause deformation or corrosion of the front

panel's plastic cover. Therefore, prior to installing the PL be sure to confirm the type of conditions

that will be present in the PL's operating environment.

If the installation gasket is used for a long period of time, or if the unit and its gasket are removed from

the panel, the original level of the protection cannot be guaranteed. To maintain the original protec-

tion level, you need to replace the installation gasket regularly.

0.1mg/m

19.6m/s

Less than 100 Ω , or your country's applicable standard.

W 405mm [15.94in.] x H 350mm [13.78in.] x D 74mm [2.91in.]

AC 100V to AC 240V

AC 85V to AC 265V

50/60Hz

1 cycle or less

65VA or less

30A (normal), 45A (40

AC 1500V at 20mA for 1 minute

(between charging and FG terminals)

Greater than 10M Ω at DC 500V

(between charging and FG terminals)

C to 40

-10

C to 60

30% RH to 85% RH (no condensation)

or less (free of conductive particles and dust)

800 to 1114hPa (2000 meters or lower)

at 10Hz to 25Hz in X, Y, Z directions for 30 minutes

Noise Voltage: 1500Vp-p

Pulse Width: 50ns, 500ns, 1 µ s

Rise Time: 1ns

Exclusive grounding only:

Equivalent to IP65f (JEM1030)

Via natural cooling

Less than 6.5kg (14.3lb)

(with HDD and FDD installed)

(excluding projections)

- 6 -