Digital Electronics FP790-T21 설치 매뉴얼 - 페이지 4
{카테고리_이름} Digital Electronics FP790-T21에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Electronics FP790-T21 17 페이지. Flat panel display
페이지 인쇄1
FP External Features
Front
J
View
Rear
View
I
H G F
Bottom
View
• Prior to attaching peripheral units to the FP, be sure the FP unit's
power cord is disconnected from the main power supply.
• To prevent an electrical shock, be sure to disconnect the FP unit's
power cord from the power supply before connecting the cord's power
terminals or any peripheral devices to the FP.
A, B
C
E
D
C
- 4 -
A: TFT type color LCD
The FP units' output display. Data
from the host are displayed.
B: Touch panel
Used to switch screens and write data
to the host.
C: Power input terminal block
Used to connect the power supply
cable.
D: Status LED (Under development)
E: Setup switches (DIP switches)
Used to set the FP's operation mode.
F: MOUSE Connector (MOUSE IN)
Used to connect a mouse.
G: MOUSE Host connector (MOUSE
OUT)
Sends mouse output data from the FP.
Connects to the Host's PS\2 equivalent
Mouse input connector.
H: Serial I/F Connector (RS-232C)
Serial RS-232C interface. This
connects a serial cable to the FP, and
sends FP touch panel data to the Host,
and Host commands to the FP.
I: Analog RGB I/F connector
Analog RGB interface connector
J: Front Maintenance Cover (unused)