Digital Electronics Corporation PS-3651A series 설치 매뉴얼 - 페이지 3

{카테고리_이름} Digital Electronics Corporation PS-3651A series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Electronics Corporation PS-3651A series 4 페이지. Ps365xa-hd250

페이지 인쇄

Installation

• Shock Danger! Be sure to unplug the

PS-A unit from its power supply prior to

installing the HDD unit.

• Since the HDD unit and PS-A's the cir-

cuit board are a precision instrument

that has a low resistance to shocks, be

sure it is neither hit by nor pressed

strongly against another object when

installing it.

• The electric power may be supplied to

the PS-A unit even when the screen

blacks out (such as the standby

mode). Be sure to confirm that the

power cable on the rear side of the

PS-A is disconnected.

When attaching the HDD unit

to the PS-3650A

(1) Turn OFF the power switch of the PS-A

and remove the power cable. Place the

PS-A on a flat, level surface facing the

display face downwards.

(2) Unscrew the expansion board cover's

screws (2) and remove the expansion

board cover.

(3) Unscrew the expansion board base's

screws (4) and remove the expansion

board base.

(4) Remove the DISK cover.

Serial ATA Interface

(5) Mount the HDD unit vertically on the

circuit board and plug the HDD unit

cable connector in the Serial ATA

interface.

• Mount the HDD unit vertically and

thoroughly not to hit the circuit board.

Otherwise, it may cause a malfunction

or damage the HDD unit and PS-A.

(6) Fix the HDD unit with the screws (4)

which are contained in your package.

The torque required to tighten these

screws is 0.5 to 0.6 N·m.