Digital Electronics Corporation PLB911-42 설치 매뉴얼 - 페이지 12

{카테고리_이름} Digital Electronics Corporation PLB911-42에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Electronics Corporation PLB911-42 17 페이지.

Installing the PL

Use the following procedures to install the PL into a solid panel.

When using the optional 19 inch Mount Panel, refer to

the PL-RM200 unit's Installation guide for details.

1) Use the six (6) attachment screws included in the PL's packing box to attach

the mounting brackets to the PL main unit. Be careful that each bracket is

attached to the correct side.

2) Drill the attachment holes in the Installation Panel. Be sure to follow the

dimensions given for the attachment holes.

(Unit : mm [in.] - excluding projections)

105.4 [4.15]

90.1 [3.55]

• Depending on the panel's material and design, the panel's instal-

lation surface may need to be strengthened. If high levels of vibra-

tion are expected and the PL's installation surface (i.e. an opera-

tion panel's door, etc.) can move (i.e.open or close) due consider-

ation should be given to the PL's weight.

• Be sure all installation tolerances are maintained to prevent the

unit from falling out of its installation panel.

+0.04

360.3

[14.19

–0

Front View

]