Digital Electronics Corporation PLB911-42 설치 매뉴얼 - 페이지 14

{카테고리_이름} Digital Electronics Corporation PLB911-42에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Electronics Corporation PLB911-42 17 페이지.

Use the following steps when connecting the power cord to the PL's power

terminals.

POWER

I :ON

o :OFF

1) Confirm that the PL unit's power switch is

turned OFF. Then, remove the power terminal's

transparent plastic cover.

Black

White

Green/

Yellow

Attachment

Screws

Transparent

Cover

2) Loosen and remove the middle

three(3) screws from the terminal

strip. Align the crimp terminals

with each screw hole, and tighten

the screws.

• Crimp Terminal Types :

V1.25-3, by J.S.T. or equivalent

(JIS standard part number :

RAV1.25-3)

• Crimp terminals must be the same

as shown below.

Max. 6.0 mm

• The colors in the figure above

are for the cable which came

with the PL.

• This power cable is designed

only for AC100/115V use. Be

sure to use a different cable

when using other than AC100/

115V power.

3) Reattach the terminal strip's

transparent cover with the

attatchment screws.

Transparent Cover

Screws

φ φ φ φ φ 3.2 mm or larger