Digital Equipment Prioris HX 6000 설치 매뉴얼 - 페이지 10

{카테고리_이름} Digital Equipment Prioris HX 6000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Equipment Prioris HX 6000 17 페이지.
Digital Equipment Prioris HX 6000에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)

페이지 인쇄

Power Up the Server and Update Your BIOS

1. Power up the server and enable MS-DOS.

2. Insert the BIOS Update diskette into drive A and change the directory

to upgrade. Example:

A:\cd upgrade

2. At the MS-DOS prompt, type: phlash

3. You BIOS is updated automatically.

NOTE: DO NOT power down the system once this procedure

has started. If the system loses power, or if at the end of this

procedure the system fails, please refer to the section,

"Troubleshooting – Using the Crisis Recovery Diskette if

Necessary."

The system will reboot at the termination of the upgrade procedure.

4. Remove the diskette from Drive A.

Reset Switches on the Main Logic Board

1. As described previously, power down the server.

2. Make sure that the following switches, shown in Figure 1, are set

to disabled to prevent any unauthorized update to your BIOS:

SW1-1

SW1-3

BIOS upgrade

Boot block update

Prioris HX 6000 Server Powergrade Kit

Disabled (Off)