Digital Equipment Prioris HX 6000 Kurulum Kılavuzu - Sayfa 10

Sunucu Digital Equipment Prioris HX 6000 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Digital Equipment Prioris HX 6000 17 sayfaları.
Ayrıca Digital Equipment Prioris HX 6000 için: Kurulum Kılavuzu (16 sayfalar)

Sayfayı Yazdır

Power Up the Server and Update Your BIOS

1. Power up the server and enable MS-DOS.

2. Insert the BIOS Update diskette into drive A and change the directory

to upgrade. Example:

A:\cd upgrade

2. At the MS-DOS prompt, type: phlash

3. You BIOS is updated automatically.

NOTE: DO NOT power down the system once this procedure

has started. If the system loses power, or if at the end of this

procedure the system fails, please refer to the section,

"Troubleshooting – Using the Crisis Recovery Diskette if

Necessary."

The system will reboot at the termination of the upgrade procedure.

4. Remove the diskette from Drive A.

Reset Switches on the Main Logic Board

1. As described previously, power down the server.

2. Make sure that the following switches, shown in Figure 1, are set

to disabled to prevent any unauthorized update to your BIOS:

SW1-1

SW1-3

BIOS upgrade

Boot block update

Prioris HX 6000 Server Powergrade Kit

Disabled (Off)