Digital Equipment Prioris XL 5166 설치 매뉴얼 - 페이지 16

{카테고리_이름} Digital Equipment Prioris XL 5166에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Equipment Prioris XL 5166 17 페이지. Cpu powergrade kit

Prioris XL and XLDP Server Powergrade Kit

Install the New Medallion

Install the new medallion (product nameplate) to identify your server to service

personnel. To replace the nameplate:

1. Remove the tape on the back to expose the adhesive surface.

2. Press the new nameplate into place over the previous nameplate.

1. Install the left side panel and lock the server.

NOTE:

removed.

2. Connect the cables, the monitor power cord, and the server power cord to

the back of the server.

The SCU enables you to check or change your server's configuration. Run

the SCU to configure your server for the new CPU chip or module.

To start and run the SCU:

1. Insert the SCU diskette into drive A and turn on your server. The diskette

should boot automatically from the diskette.

2. When the SCU title appears, press any key to continue. Afterwards,

follow the instructions on your screen to access the SCU main menu.

3. From the main menu, press the up or down arrow to highlight an item and

then press Enter to select it. Press F1 at any time for help about a

selection.

4. From the main menu select Configure Computer and then View

and Edit Details. Example:

If you installed a video option card, select the Advanced Control

Group and disable the Embedded - PCI VGA controller.

The server will not power up with the side panel