Siemens SIMATIC ET 200SP HA 장비 매뉴얼 - 페이지 14

{카테고리_이름} Siemens SIMATIC ET 200SP HA에 대한 장비 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC ET 200SP HA 38 페이지. Distributed i/o devices busadapter for distributed i/o
Siemens SIMATIC ET 200SP HA에 대해서도 마찬가지입니다: 매뉴얼 (32 페이지), 매뉴얼 (50 페이지), 매뉴얼 (34 페이지), 매뉴얼 (38 페이지), 장비 매뉴얼 (44 페이지), 장비 매뉴얼 (50 페이지), 장비 매뉴얼 (46 페이지), 장비 매뉴얼 (42 페이지), 장비 매뉴얼 (44 페이지), 장비 매뉴얼 (36 페이지), 장비 매뉴얼 (38 페이지)

페이지 인쇄

1. I/O Module

Connection

4.4 Example connection scheme for DI-2 wire sensor connection

4.2

Pin assignment (2-wire connection)

Definition

The pin assignment provides information about the arrangement and identification of the

terminals when wiring a connector.

Description

The pin assignment on the left side of the terminal blocks with potential distributor corresponds

to the following assignment:

Pin assignment (1-wire connection) (Page 13)

The potential distributor with the following terminals is located on the right side of the terminal

block:

• 32 L+ terminals for power supply of sensors.

• Four M terminals

Note

• The L+ terminals on the potential distributor are intended exclusively for the sensors

connected to the I/O module using a 2-wire connection system.

• You may not use these terminals as voltage source for other devices in the system.

4.3

Sample connection scheme for 1-wire connection

Example

For example, when using an external supply voltage with ground connection to M

4.4

Example connection scheme for DI-2 wire sensor connection

Example

This connection variant is only permitted with terminal blocks of the type "potential distributor".

Equipment Manual, 10/2021, A5E48262828-AB

DI 32x24VDC HA