Siemens SIMATIC ET 200SP HA Uitrustingshandleiding - Pagina 14

Blader online of download pdf Uitrustingshandleiding voor {categorie_naam} Siemens SIMATIC ET 200SP HA. Siemens SIMATIC ET 200SP HA 38 pagina's. Distributed i/o devices busadapter for distributed i/o
Ook voor Siemens SIMATIC ET 200SP HA: Handmatig (32 pagina's), Handmatig (50 pagina's), Handmatig (34 pagina's), Handmatig (38 pagina's), Uitrustingshandleiding (44 pagina's), Uitrustingshandleiding (50 pagina's), Uitrustingshandleiding (46 pagina's), Uitrustingshandleiding (42 pagina's), Uitrustingshandleiding (44 pagina's), Uitrustingshandleiding (36 pagina's), Uitrustingshandleiding (38 pagina's)

Connection

4.2

Pin assignment (2-wire connection)

Definition

The pin assignment provides information about the arrangement and identification of the

terminals when wiring a connector.

Description

The pin assignment on the left side of the terminal blocks with potential distributor corresponds

to the following assignment:

Pin assignment (1-wire connection) (Page 13)

The potential distributor with the following terminals is located on the right side of the terminal

block:

• 32 L+ terminals for power supply of sensors.

• Four M terminals

Note

• The L+ terminals on the potential distributor are intended exclusively for the sensors

connected to the I/O module using a 2-wire connection system.

• You may not use these terminals as voltage source for other devices in the system.

4.3

Example

For example, when using an external supply voltage with ground connection to M

4.4

Example connection scheme for DI-2 wire sensor connection

Example

This connection variant is only permitted with terminal blocks of the type "potential distributor".

Equipment Manual, 10/2021, A5E48262828-AB

DI 32x24VDC HA