Siemens SIMOGEAR BA 2730 사용 설명서 - 페이지 17

{카테고리_이름} Siemens SIMOGEAR BA 2730에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMOGEAR BA 2730 28 페이지. Geared motor with encoder for safety-relevant applications
Siemens SIMOGEAR BA 2730에 대해서도 마찬가지입니다: 사용 설명서 (30 페이지)

페이지 인쇄

2.4

Commissioning the encoder

Inadequately qualified personnel

If the encoder is electrically installed by inadequately qualified personnel then the functional

safety can be disabled.

Only qualified personnel are authorized to carry out the work.

These persons must be knowledgeable about:

• Topics relating to functional safety

• Legislation, safety regulations and standards for functional safety

• Content of the detailed operating instructions provided

For commissioning, observe the operating instructions Sendix SIL Encoders for Functional

Safety from the Kübler company.

Complete the checklist shown below before commissioning the encoder.

Table 2- 1

FDU.............................................................

Factory serial number, see rating plate ③

The designated product is designed for installation in a machine. Commissioning is prohibited until it

has been established that the end product conforms with Directive 2006/42/EC.

Measure

Is the signal yellow Safety Integrated marking on the front cover and SI04 marking on

the rating plate?

Is the geared motor free of any damage?

Are the operating instructions BA 2730, Sendix SIL, BA 2030, BA 2330 – and all of the

other instructions for the encoder available – and have they been carefully read?

Does the data stamped on the geared motor rating plate correspond to the particular

application?

Is the installation altitude below 1000 m above sea level?

Is the ambient temperature maintained between -20 °C and +40 °C

Is operation under harsh industrial environments completely ruled out, for example the

offshore or chemical industry, and areas with direct exposure to seawater or spraying

seawater?

Was the geared motor correctly installed and aligned to rule out vibration and shock?

Does the motor manifest vibration levels and shock below those according to

EN 60721-3-3, up to and including Class 3M3.

BA 2730

Operating Instructions, 08/2015, A5E36448105

WARNING

Checklist for commissioning the encoder

Securing functional safety

2.4 Commissioning the encoder

Yes