Siemens SIMOGEAR BA 2730 Manual de Instruções - Página 17
Procurar online ou descarregar pdf Manual de Instruções para Equipamento industrial Siemens SIMOGEAR BA 2730. Siemens SIMOGEAR BA 2730 28 páginas. Geared motor with encoder for safety-relevant applications
Também para Siemens SIMOGEAR BA 2730: Manual de Instruções (30 páginas)
Imprimir página
2.4
Commissioning the encoder
Inadequately qualified personnel
If the encoder is electrically installed by inadequately qualified personnel then the functional
safety can be disabled.
Only qualified personnel are authorized to carry out the work.
These persons must be knowledgeable about:
• Topics relating to functional safety
• Legislation, safety regulations and standards for functional safety
• Content of the detailed operating instructions provided
For commissioning, observe the operating instructions Sendix SIL Encoders for Functional
Safety from the Kübler company.
Complete the checklist shown below before commissioning the encoder.
Table 2- 1
FDU.............................................................
Factory serial number, see rating plate ③
The designated product is designed for installation in a machine. Commissioning is prohibited until it
has been established that the end product conforms with Directive 2006/42/EC.
Measure
Is the signal yellow Safety Integrated marking on the front cover and SI04 marking on
the rating plate?
Is the geared motor free of any damage?
Are the operating instructions BA 2730, Sendix SIL, BA 2030, BA 2330 – and all of the
other instructions for the encoder available – and have they been carefully read?
Does the data stamped on the geared motor rating plate correspond to the particular
application?
Is the installation altitude below 1000 m above sea level?
Is the ambient temperature maintained between -20 °C and +40 °C
Is operation under harsh industrial environments completely ruled out, for example the
offshore or chemical industry, and areas with direct exposure to seawater or spraying
seawater?
Was the geared motor correctly installed and aligned to rule out vibration and shock?
Does the motor manifest vibration levels and shock below those according to
EN 60721-3-3, up to and including Class 3M3.
BA 2730
Operating Instructions, 08/2015, A5E36448105
WARNING
Checklist for commissioning the encoder
Securing functional safety
2.4 Commissioning the encoder
Yes
No
17