Digital Equipment DEC WANcontroller 622 문제 해결 - 페이지 4
{카테고리_이름} Digital Equipment DEC WANcontroller 622에 대한 문제 해결을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Equipment DEC WANcontroller 622 8 페이지.
페이지 인쇄Problem Solving Flowchart – note the NIC LED state and follow the procedure indicated
ATTENTION
or
There is a possible problem
with the NIC.
Perform a module loopback
test on the NIC.
Load the DECNIS software.
Test
See the DEC Network
Yes
successful?
Integration Server Software
(READY state)
Installation card for the load-
host operating system.
No
Load
There is a possible problem
successful?
with the extension cables.
Yes
The problem was a loose
cable connection.
FAULT
D
No
A
Test
No
successful?
(READY state)
Yes
There is a possible problem
with the NIC.
D
C
Replace the adapter cable.
D
For details of tests and procedures, refer to the panel with the matching flag (see overleaf).
READY
The problem could be a
loose cable connection.
Check all extension cables
are properly connected.
If this does not solve the
problem, continue along this
path of the flowchart.
Do
the system
Perform an NCL loopback
displays on the processor
Yes
test on the adapter cable
card display indicate that the
attached to the faulty port.
software is loaded and
running?
No
Perform a module loopback
test on the NIC.
successful?
A
Perform NCL loopback tests on the extension cables.
If there is more than one cable, test all cables in sequence:
1. Test the cable nearest the adapter cable.
2. If that cable passes the test, test the next section of cable.
3. Repeat step 2 until all sections of the cable have been
tested, or the test fails.
All
tests successful?
Check the local modem
and remote connections –
see DEC Network Integration
Server Problem Solving.
Fast Flicker
Check the LED display on
the processor card, then see
the Installation and Service
Manual for your DECNIS.
B
Test
Yes
B
No
Replace the section of cable
that failed the test.
D
Yes
LKG-5730-91I