Siemens SINUMERIK 808D 서비스 매뉴얼 - 페이지 42

{카테고리_이름} Siemens SINUMERIK 808D에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SINUMERIK 808D 48 페이지. Connecting with v60 driver
Siemens SINUMERIK 808D에 대해서도 마찬가지입니다: 사용 설명서 (34 페이지), 서비스 매뉴얼 (46 페이지), 지침 (2 페이지), 설치 매뉴얼 (48 페이지)

페이지 인쇄
Siemens SINUMERIK 808D 서비스 매뉴얼
4.3.4

Alarm 700023

Alarm description
The program is incorrect. The programmed tool position number is larger than the maximum tool position number.
PLC information
PLC address: DB1600.DBX2.7
Subroutine: MAIN (OB1)
Remedy
Check the content of the part program, and edit the program according to the actual number of tools created.
4.3.5

Alarm 700024

Alarm description
The maximum number of tools is not set properly (should be set to 4 or 6) on the control system.
PLC information
PLC address: DB1600.DBX3.0
Subroutine: MAIN (OB1)
Remedy
Check whether the setting of MD14510[20] (max. tool number) is correct.
4.3.6

Alarm 700025

Alarm description
No position signals can be detected from the turret.
PLC information
PLC address: DB1600.DBX3.1
Subroutine: MAIN (OB1)
Remedy
● Check the turret encoder to see whether the turret signal interface is damaged.
● Check whether the turret has fault.
● Check the corresponding I/O interface on the back of the PPU for the following:
–
Whether the connections are disconnected/broken
–
Whether the terminals are damaged/loose
–
Whether pin 10 is connected to 0 V properly
42
Service Manual
01/2017