Siemens SINUMERIK 808D 설치 매뉴얼 - 페이지 29
{카테고리_이름} Siemens SINUMERIK 808D에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SINUMERIK 808D 48 페이지. Connecting with v60 driver
Siemens SINUMERIK 808D에 대해서도 마찬가지입니다: 사용 설명서 (34 페이지), 서비스 매뉴얼 (46 페이지), 서비스 매뉴얼 (48 페이지), 지침 (2 페이지)
페이지 인쇄
3.3.5
Handwheel inputs - X10
Pin assignment
Type
Cable
Table 3- 9
Illustration
Connecting
You are allowed to connect at most 2 electronic handwheels at connector X10 on the PPU.
The handwheels must meet the following requirements:
Transmission procedure
Signals
Max. input frequency
Phase shift between Track A to Track
B
Supply
Electrical Installation Manual
Operating Instructions, 12/2014, 6FC5397-2EP10-0BA0
Mini Combicon 10-pin
Max. length: 3m
Pin assignment of X10
Pin
1
2
3
4
5
6
7
8
9
10
3.3 Connecting the interfaces on the PPU
Signal
Comment
A1
TRACK A, handwheel 1
A1_N
NEGATIVE TRACK A, handwheel 1
B1
TRACK B, handwheel 1
B1_N
NEGATIVE TRACK B, handwheel 1
+5V
+5V power output
M
Ground
A2
TRACK A2, handwheel 2
A2_N
NEGATIVE TRACK A2, handwheel 2
B2
TRACK B2, handwheel 2
B2_N
NEGATIVE TRACK B2, handwheel 2
5V square wave signals (TTL level or RS422)
Track A as a true and negative signal (U
Track B as a true and negative signal (U
500 kHz
90
±30
o
o
5V, max. 250 mA
Connecting
U
)
a1
a1
U
)
a2
a2
29