Siemens SINUMERIK 808D 설치 매뉴얼 - 페이지 31

{카테고리_이름} Siemens SINUMERIK 808D에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SINUMERIK 808D 48 페이지. Connecting with v60 driver
Siemens SINUMERIK 808D에 대해서도 마찬가지입니다: 사용 설명서 (34 페이지), 서비스 매뉴얼 (46 페이지), 서비스 매뉴얼 (48 페이지), 지침 (2 페이지)

페이지 인쇄

Connecting

Damage to controller or power supply

Pin 5, pin 8 or pin 12 of X51/52/53 are used for +24V power output.

Incorrect connection of them will lead to damage to the CNC controller or the power supply.

Do not connect pin 5, pin 8 or pin 12 of X51/52/53 to ground.

Note

X51/52/53 does not support hot plugging.

Note

Filter

A line filter (rated current: 16 A, protection level: IP20) is required so that the system can

pass the CE certification (radiated emission test or conducted emission test). The order

number of Siemens recommended filter is 6SN1111-0AA01-1BA1.

Note

Circuit breaker

You can install a mains linear breaker (rated current: 15 A for 7 A or 10 A version of the drive

and 10 A for 4 A or 6 A version of the drive; rated voltage: 250 VAC) to protect the system.

As mentioned before, the SINUMERIK 808D control system can control three axes (X axis, Y

axis and Z axis). To do so, you need to connect the control system via the three pulse drive

interfaces (X51: X axis, X52: Y axis and X53: Z axis) separately to three SINAMICS V60

drives.

The connection diagram between the SINUMERIK 808D (X51: the X axis) and the

SINAMICS V60 is shown as follows. You can connect X52 (the Y axis) and X53 (the Z axis)

in the same way.

Electrical Installation Manual

Operating Instructions, 12/2014, 6FC5397-2EP10-0BA0

CAUTION

3.3 Connecting the interfaces on the PPU

Connecting