Siemens SINUMERIK 808D Manuale di installazione - Pagina 31
Sfoglia online o scarica il pdf Manuale di installazione per Apparecchiature industriali Siemens SINUMERIK 808D. Siemens SINUMERIK 808D 48. Connecting with v60 driver
Anche per Siemens SINUMERIK 808D: Manuale di istruzioni per l'uso (34 pagine), Manuale di servizio (46 pagine), Manuale di servizio (48 pagine), Istruzioni (2 pagine)
Stampa la pagina
Connecting
Damage to controller or power supply
Pin 5, pin 8 or pin 12 of X51/52/53 are used for +24V power output.
Incorrect connection of them will lead to damage to the CNC controller or the power supply.
Do not connect pin 5, pin 8 or pin 12 of X51/52/53 to ground.
Note
X51/52/53 does not support hot plugging.
Note
Filter
A line filter (rated current: 16 A, protection level: IP20) is required so that the system can
pass the CE certification (radiated emission test or conducted emission test). The order
number of Siemens recommended filter is 6SN1111-0AA01-1BA1.
Note
Circuit breaker
You can install a mains linear breaker (rated current: 15 A for 7 A or 10 A version of the drive
and 10 A for 4 A or 6 A version of the drive; rated voltage: 250 VAC) to protect the system.
As mentioned before, the SINUMERIK 808D control system can control three axes (X axis, Y
axis and Z axis). To do so, you need to connect the control system via the three pulse drive
interfaces (X51: X axis, X52: Y axis and X53: Z axis) separately to three SINAMICS V60
drives.
The connection diagram between the SINUMERIK 808D (X51: the X axis) and the
SINAMICS V60 is shown as follows. You can connect X52 (the Y axis) and X53 (the Z axis)
in the same way.
Electrical Installation Manual
Operating Instructions, 12/2014, 6FC5397-2EP10-0BA0
CAUTION
3.3 Connecting the interfaces on the PPU
Connecting
31