Siemens SINUMERIK 828D Turning 매뉴얼 - 페이지 5

{카테고리_이름} Siemens SINUMERIK 828D Turning에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SINUMERIK 828D Turning 49 페이지. Output of setpoints to analog drives - retrofit solution
Siemens SINUMERIK 828D Turning에 대해서도 마찬가지입니다: 연결 지침 (16 페이지)

페이지 인쇄

1. Schematic Diagram

1 Introduction

Fig. 1-2 SINUMERIK 828D with SINAMICS HLA

1.3

Requirements

Before you can commission a SINAMICS HLA, you must perform the following

steps:

•

Install CNC software version V4.8.

A separate application description exists for software version V4.7.

•

Install a special system data block (SDB) in the SINUMERIK 828D so that you

can use PROFIBUS telegram 166.

You can obtain the SDB through PridaNet.

•

Parameterize the encoders on the SINAMICS HLA.

With software version V4.8, you can parameterize the encoders as linear or

rotary. With software version V4.7, only linear parameterization is possible.

Note

Do not operate real hydraulic axes on the SINUMERIK 828D.

Sollwertausgabe an analoge Antriebe

Entry ID: 109761423,

V1.0,

10/2018