Siemens SINUMERIK 828D Turning Manuel - Sayfa 5

Endüstriyel Ekipmanlar Siemens SINUMERIK 828D Turning için çevrimiçi göz atın veya pdf Manuel indirin. Siemens SINUMERIK 828D Turning 49 sayfaları. Output of setpoints to analog drives - retrofit solution
Ayrıca Siemens SINUMERIK 828D Turning için: Bağlantı Talimatları (16 sayfalar)

Sayfayı Yazdır
Siemens SINUMERIK 828D Turning Manuel
1 Introduction
Fig. 1-2 SINUMERIK 828D with SINAMICS HLA
1.3

Requirements

Before you can commission a SINAMICS HLA, you must perform the following
steps:
•
Install CNC software version V4.8.
A separate application description exists for software version V4.7.
•
Install a special system data block (SDB) in the SINUMERIK 828D so that you
can use PROFIBUS telegram 166.
You can obtain the SDB through PridaNet.
•
Parameterize the encoders on the SINAMICS HLA.
With software version V4.8, you can parameterize the encoders as linear or
rotary. With software version V4.7, only linear parameterization is possible.
Note
Do not operate real hydraulic axes on the SINUMERIK 828D.
Sollwertausgabe an analoge Antriebe
Entry ID: 109761423,
V1.0,
10/2018
5