Siemens SINUMERIK 828D Turning Manuel - Sayfa 4

Endüstriyel Ekipmanlar Siemens SINUMERIK 828D Turning için çevrimiçi göz atın veya pdf Manuel indirin. Siemens SINUMERIK 828D Turning 49 sayfaları. Output of setpoints to analog drives - retrofit solution
Ayrıca Siemens SINUMERIK 828D Turning için: Bağlantı Talimatları (16 sayfalar)

Sayfayı Yazdır

1. Schematic Diagram

1 Introduction

Introduction

1.1

Overview

If your planned machine retrofit comprises replacement of the controller only and

you wish to continue using the analog drives, you must define the setpoints in an

analog form.

If you install a SINUMERIK 828D as part of the retrofit, you must output the analog

setpoints to the axes and spindles via a SINAMICS HLA.

In addition, you can use the analog interface (X252) of the Panel Processing Unit

(PPU) to control an analog spindle, for example.

Fig. 1-1 SINAMICS HLA

1.2

Schematic diagram

The diagram below shows a connection example of a fully equipped

SINUMERIK 828D:

•

2 SINAMICS HLA

•

4 analog feed axes

•

1 analog spindle at the X252 interface of the PPU.

•

Optional: 2 digital axes on a SINAMICS S120 (see Section

telegrams of the system data block

Note

Do not use a SINAMICS NX10 or SINAMICS NX15.

Sollwertausgabe an analoge Antriebe

Entry ID: 109761423,

V1.0,

10/2018

(SDB))

Address space and