Siemens SINUMERIK 828D Turning Manual - Página 4
Procurar online ou descarregar pdf Manual para Equipamento industrial Siemens SINUMERIK 828D Turning. Siemens SINUMERIK 828D Turning 49 páginas. Output of setpoints to analog drives - retrofit solution
Também para Siemens SINUMERIK 828D Turning: Instruções de ligação (16 páginas)
Imprimir página
1 Introduction
Introduction
1
1.1
Overview
If your planned machine retrofit comprises replacement of the controller only and
you wish to continue using the analog drives, you must define the setpoints in an
analog form.
If you install a SINUMERIK 828D as part of the retrofit, you must output the analog
setpoints to the axes and spindles via a SINAMICS HLA.
In addition, you can use the analog interface (X252) of the Panel Processing Unit
(PPU) to control an analog spindle, for example.
Fig. 1-1 SINAMICS HLA
1.2
Schematic diagram
The diagram below shows a connection example of a fully equipped
SINUMERIK 828D:
•
2 SINAMICS HLA
•
4 analog feed axes
•
1 analog spindle at the X252 interface of the PPU.
•
Optional: 2 digital axes on a SINAMICS S120 (see Section
telegrams of the system data block
Note
Do not use a SINAMICS NX10 or SINAMICS NX15.
Sollwertausgabe an analoge Antriebe
Entry ID: 109761423,
V1.0,
10/2018
(SDB))
Address space and
4