Siemens SIPART PS2 설치 지침

{카테고리_이름} Siemens SIPART PS2에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIPART PS2 4 페이지. Mounting bracket kit
Siemens SIPART PS2에 대해서도 마찬가지입니다: 설치 지침 (4 페이지), 사용 설명서 (28 페이지), 하드웨어 설치 매뉴얼 (30 페이지), 기술 설명 (26 페이지), 간결한 사용 설명서 (35 페이지), 키트 설치 지침 (9 페이지), 설치 지침 (11 페이지)

페이지 인쇄

Siemens

Energy & Automation

Valve Positioner Mounting Kits for Rotary Actuators

This Instruction describes the use of a Siemens valve positioner mounting kit to mount a Siemens SiPART® PS2 or

ValvePAC™ Series 760 valve positioner on a typical rotary valve actuator.

positioner and for the actuator should be available for reference. If assistance is needed, refer to the

Customer/Product Support section of this instruction.

Figure 1 shows typical mechanical feedback configurations. The PS2 and Model 760 mount similarly and they use

similar feedback components.

KIT CONTENTS AND VARIATIONS

Each mounting kit contains:

•

A main bracket for the particular positioner-to-actuator mounting requirements

•

Hardware to mount the bracket to the valve positioner

•

Hardware to mount the bracket to the valve actuator – When bracket-to-actuator mounting hardware is not

supplied, actuator hardware that aligns with the main bracket mounting holes is removed from the actuator and

used to secure the main bracket.

•

Additional hardware (e.g. spacers) as required – An installation may

require use of spacers, supplied in some kits, between the positioner

mounting bracket and the actuator.

•

Feedback components to transfer the rotary motion of the actuator to the

valve positioner input shaft (may be sold separately)

•

When using a sheet metal coupler (see the detail at right), ensure that

the PS2 feedback arm attaches securely to a C-style metal coupling by

positioning the included metal spacer between the coupling and the

lockwasher.

KIT INSTALLATION

Before proceeding, read the actuator and valve positioner installation instructions and note all warnings and

cautions. Also, read the following cautions as they apply to all procedures in this instruction.

CAUTION

Perform the following steps to mount the positioner on the actuator and complete the feedback connection. Some

steps are performed only for certain models or certain actuator configurations as indicated.

This publication provides kit installation information and is intended to complement the product manuals. Refer to the product

manuals for applicable warnings and cautions and for detailed product procedures and specifications.

KIT INSTALLATION INSTRUCTION

SiPART PS2 and ValvePAC Series 760

Do not apply supply pressure to the actuator or the valve positioner

during the installation process. Applying supply pressure before the

equipment is properly mounted could cause unexpected movement that

could lead to personal injury or equipment damage.

Installation instructions for the valve

C-Style Sheet

Metal Coupling

15900-745

Rev 3

November 2007

Spacer