Siemens SIWAREX WL230 BB-S SA 장비 매뉴얼 - 페이지 29

{카테고리_이름} Siemens SIWAREX WL230 BB-S SA에 대한 장비 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIWAREX WL230 BB-S SA 50 페이지. Base plate and elastomer bearing bb-s sa
Siemens SIWAREX WL230 BB-S SA에 대해서도 마찬가지입니다: 매뉴얼 (36 페이지), 사용 설명서 (48 페이지), 사용 설명서 (44 페이지)

페이지 인쇄
Siemens SIWAREX WL230 BB-S SA 장비 매뉴얼
Figure 5-1
1. Insert the pendulum bolt enclosure
The arrow on the front of the load cell points in the measuring direction.
2. Check the flat seal
3. Cover the pendulum bolt
4. Insert the pendulum bolt into the pendulum bolt enclosure
5. Insert the load cell with the pendulum bolt into the compact installation unit.
Figure 5-2
6. For the version for 0.5 t and 1 t, you will also need a spacing strip.
– Place the spacing strip
7. Screw the load cell
washers
– For the version for 0.5 t and 1 t, you also need the spacing strip.
– When screwing tight, do not hold the load cell to counter the force. This will prevent
SB-S SA
Equipment Manual, 12/2020, A5E02390707B-03
Placing the pendulum bolt enclosure and the pendulum bolt into the load cell
②
for damage.
③
Inserting the load cell
③
aligned with the threaded holes of the base plate and are flush with the plate. The spacing
strip is not symmetrical.
①
onto the base plate using two hexagon bolts and the corresponding
④
.
damage to the load cell.
Figure 5-3
Compact mounting unit with load cell pre-mounted
5.2 Installing the compact installation unit
①
into the load cell.
with ball bearing grease.
②
on the base plate
in such a way that the bore holes are
Installation
④
.
29