Siemens SIWAREX WL270 CP-S SA 사용 설명서 - 페이지 23

{카테고리_이름} Siemens SIWAREX WL270 CP-S SA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIWAREX WL270 CP-S SA 40 페이지. Mounting plates cp-s sa
Siemens SIWAREX WL270 CP-S SA에 대해서도 마찬가지입니다: 사용 설명서 (38 페이지)

페이지 인쇄

5.2

Mounting the pressure piece set

5.2.1

General installation information

The installation conditions vary widely. The dead load of the load bearing implement can be

very low or relatively high. You might be dealing with a container, platform or a roller

conveyor. The following installation instructions can therefore only describe the general

procedures.

Always set up the load bearing implement on dummies in order to protect the load cells from

damage during installation.

The load bearing implement then only has to be raised a few millimeters from bracket to

bracket in order to position the pressure piece set. The following description of the

installation is based on this assumption.

Note

Maintenance-friendly design

When planning the layout, ensure that the load cells are easily accessible once they are

installed.

Depending on the installation conditions, the detailed procedure may deviate from the

following description.

5.2.2

Overview

The following actions are required in order to install the pressure piece set.

1. Preparing the load cell

2. Preparing the pressure piece set

3. Installing the load cell with pressure piece set

4. Checking the installation

The actions are described in detail in the following.