Siemens SIWAREX WL280 사용 설명서 - 페이지 26

{카테고리_이름} Siemens SIWAREX WL280에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIWAREX WL280 42 페이지. Pressure piece sets rn-s sa

Installation

5.2 Mounting the pressure piece set

Procedure

NOTICE

Personal injuries, damage to the load cells

Insufficiently secured loads can fall and cause injuries or material damage. Therefore, use

suitable hoisting equipment to lift the load bearing implement. Observe the appropriate

safety regulations.

NOTICE

Destruction of the load cells and the pressure piece set

Check that the load cells and installation unit are installed correctly, e.g. by checking the

mounting dimensions and oscillation distances. Incorrect assembly can lead to the

destruction of the load cell and the installation unit.

Ensure that the cable does not become damaged or is cut off.

To prevent water from penetrating, lay the cables through cable glands in the form of a

vertical downwards loop.

Adapt the procedure to the installation conditions. In the case of the small 60 kg to 280 kg

cells, observe the mounting position.

①

Bearing surfaces of the pendulum support

②

RN-S SA 60 kg to 280 kg load cell ⇒ Caution: Note the mounting position of the pendulum support!

③

RN-S SA 0.5 t / 1.0 t load cell

Figure 5-4

Inserting load cells

1. Grease the bearing surfaces of the pendulum support with a bearing lubricant.

2. Insert load cell with the pendulum support.

3. Lower the load bearing implement onto the load cells.

Operating Instructions, 09/2013, A5E32962759A-01

RN-S SA