Siemens TIASTAR 사용 설명서 - 페이지 2

{카테고리_이름} Siemens TIASTAR에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens TIASTAR 44 페이지. Motor control center

THIS EQUIPMENT CONTAINS HAZARDOUS VOLTAGES. DEATH, SERIOUS PERSONAL INJURY, OR PROPERTY DAMAGE CAN

RESULT IF SAFETY INSTRUCTIONS ARE NOT FOLLOWED. ONLY QUALIFIED PERSONNEL SHOULD WORK ON OR AROUND

THIS EQUIPMENT AFTER BECOMING THOROUGHLY FAMILIAR WITH ALL WARNINGS, SAFETY NOTICES, AND

MAINTENANCE PROCEDURES CONTAINED HEREIN.

THE SUCCESSFUL AND SAFE OPERATION OF THIS EQUIPMENT IS DEPENDENT UPON PROPER HANDLING,

INSTALLATION, OPERATION AND MAINTENANCE.

SIGNAL WORDS

The signal words "DANGER", "WARNING" and "CAUTION"

used in this manual indicate the degree of hazard that may be

encountered by the user. These words are defined as:

DANGER - For the purpose of this manual and product labels,

DANGER indicates an imminently haardous situation which, if

not avoided will result in death or serious injury.

WARNING - For the purpose of this manual and product labels,

WARNING indicates a potentially hazardous situation which, if

not avoided, could result in death or serious injury.

CAUTION - For the purpose of this manual and product labels,

CAUTION indicates a potentially hazardous situation which, if

not avoided, may result in minor or moderate injury.

Hazardous voltage.

Will cause death or serious injury.

Always de-energize and ground the equipment

before maintenance. Read and understand this

manual before installing, operating or maintaining

the equipment. Maintenance should be performed

only by qualified personnel. The use of unauthor-

ized parts in the repair of the equipment or tam-

pering by unqualified personnel may result in dan-

gerous conditions which may cause death or seri-

ous injury, or equipment or property damage.

Follow all safety instructions contained herein.

For the purposes of this manual and product labels, a quali-

fied person is one who is familiar with the installation, con-

struction, operation or maintenance of the equipment and

the hazards involved. In addition this person has the follow-

ing qualifications:

(a) is trained and authorized to energize, de-energize, clear,

ground and tag circuits and equipment in accordance

with established safety practices.

(b) is trained in the proper care and use of protective equip-

ment such as rubber gloves, hard hat, safety glasses or

face shields, flash clothing, etc., in accordance with

established safety practices.

QUALIFIED PERSON